TM-9-2350-256-20-1
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 1 OF 2
NOVEMBER 2005
TM-9-2350-256-20-1 - Page 802 of 948
TM 9-2350-256-20-1
0119 00
Installation
NOTE
When tightening fuel line fittings, draw nut up 1/16 (minimum) to 1/3 (maximum) of a turn after seating
sleeve.
1.
Install hose assembly (31) by tightening coupling nut at each end and installing elbow (32) and check valve (33) on one
end, and tee (34) on other end.
2.
Install hose assembly (27) by tightening coupling nut at each end and installing nut (28), lockwasher (29), and flat washer
(30).
3.
Install three loop clamps (24) with three self-locking nuts (25) and three screws (26).
4.
Install tube cross (21) with flat washer (22) and nut (23).
5.
Install sealing plug (20) with retaining ring (17), nut (18), and clinch sleeve (19).
6.
Install hose assembly (16) by tightening coupling nut at each end of hose assembly.
7.
Install two elbows (15) and grommet (14).
8.
Install hose assembly (13) by tightening coupling nut at each end of hose assembly.
9.
Install tube elbow (11) and tube assembly (10) by tightening coupling nut at each end of tube assembly and installing two
clamps (12).
10.
Install tube elbow (8) and tube assembly (7) by tightening coupling nut at each end of tube assembly and installing two
clamps (9).
11.
Install 12 multiple connectors (4) with 24 flat washers (6) and 12 fluid passage bolts (5).
12.
Install hose assembly (3) by tightening coupling nut at each end of hose assembly.
13.
Install two hose assemblies (2) by tightening coupling nut at each end of hose assembly.
14.
Install 10 hose assemblies (1) by tightening coupling nut at each end of hose assembly.
NOTE
Follow-on maintenance: Install engine cooling fan shroud and related parts (see WP 0146 00); Install
engine right and left upper covers (see WP 0115 00).
0119 00-4
Back to Top
