TM-9-2350-261-10

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

OPERATOR'S MANUAL

TM-9-2350-261-10 - Page 327 of 761

TM 9-2350-261-10

SET UP COMMAND POST TENT (COVERED EXTENSION) (M577A2 ONLY) — Continued

0054 00

NOTE

Two men are required on each side of frame to lift it into position on carrier.

NOTE

If you need protection against extreme cold weather, install tent liner (WP 0057 00).

7.

Attach frame to carrier at two fittings.

8.

Unroll tent cover along framework, and unfold sides and end.

9.

Lift rear of frame assembly and insert both rear legs at the same time.

10. Install two center legs in frame assembly.

11. Adjust all four legs to contour of ground.

12. Loosen the three wingnuts securing clamping strips to hull at each side of ramp.

13. Insert beaded edge of cover under clamping strip. Tighten wingnuts. Two soldiers are required (one on top of carrier

and one on ground).

14. Raise and lock ramp (WP 0015 00).

005400-3