TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 159 of 932

TM 9-2350-261-20-3

REPLACE COMMANDER’S CUPOLA COVER (M113A2 AND M1064 ONLY) — Continued

0455 00

INSTALLATION

1.

Place new seal (11) over retaining groove in cover (5). Press seal into place. Trim end of seal if needed.

2.

Install screw (10) in cover (5). Secure with new locknut (9).

3.

Align cover (5) with cupola brackets. Install two fiber washers (8) and shield (7).

4.

Apply light coat of grease to each spring (6). Install 12 springs in shield (7).

5.

Place cover (5) in vertical position. Install retainer (4) on cupola bracket. Secure with two screws (3), washers (2), and

new locknuts (1).

FOLLOW-THROUGH STEPS

1.

Adjust commander’s cupola cover latch (WP 0454 00).

2.

Close cover. Check that commander’s cupola cover is installed right (see your -10).

END OF TASK

0455 00-3/4 blank