TM-9-2350-261-20-4
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 4 OF 4
TM-9-2350-261-20-4 - Page 231 of 767
TM 9-2350-261-20-4
REPLACE M13 NBC HEATER HOSES (M1068 ONLY) — Continued
0682 00
19. If grommet (1) was removed, install new grommet on driver’s inlet hose (2). Route hose through welded frame and
insert grommet in frame.
20. Install driver’s inlet hose (2) and two clamps (3) on manifold (4) and driver’s heater (5). Tighten clamps.
21. Install clamp (6) on driver’s inlet hose (2) and commander’s inlet hose (7). Secure clamp on sponson with screw (8)
and new lockwasher (9).
22. Install clamp (10) on driver’s inlet hose (2) and commander’s inlet hose (7). Secure clamp on welded bracket with
screw (11), washer (12), and new locknut (13).
23. If bracket (14) was removed, install bracket on driver’s bulkhead with two screws (15) and new lockwashers (16).
24. Install driver’s outlet hose (17) and clamp (18) on connector (19) and driver’s heater (5). Tighten clamp.
FOLLOW-THROUGH STEPS
1.
Connect battery ground lead (WP 0294 00).
2.
Check air flow of NBC systems. See TM 3-6680-316-10.
END OF TASK
0682 00-8
Back to Top
