TM 9-2350-261-34
BLOCK POWER PLANT — Continued
0015 00
4.
Stacka4x6x10inch(10x15x25cm)block(1)
,a2x4x10inch(5x10x25cm)block(2)
,anda1x4x10inch(3
x 10 x 25 cm) block (3) under transmission side of transfer gearcase. Blocks should be 8 inches (20 cm) high.
5.
Stacka4x6x18inch(10x15x46cm)block(4)anda2x4x18inch(5x10x46cm)block(5)underrearofengine
.
Blocks should be about 7 inches (16 cm) high.
6.
Lower power plant slowly down onto blocks. Check that power plant is firmly supported by the blocks.
7.
Cover air inlet housing (6). Use wiping rag.
FOLLOW-THROUGH STEPS
1.
Install power plant in carrier (see your -20).
END OF TASK
0015 00-3/4 blank