TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 197 of 785

TM 9-2350-261-34

REPLACE ENGINE — Continued

0021 00

NOTE

Lubricate rod end bearings before assembling. Use GAA grease (see your –20).

24. Apply thin coat of antiseize compound to clean threads of three screws (18) and (14).

25. Install bracket assembly (13) on power plant. Secure with two screws (18), new lockwashers (19), and nuts (20).

TIGHTEN SCREWS TO 300-324 LB-IN (34-37 N·M) TORQUE. Use torque wrench and socket wrench set.

26. Install screw (14) and new lockwasher (17) in bottom hole of bracket assembly (13). TIGHTEN SCREW TO 264-288

LB-IN (30-33 N·M) TORQUE. Use torque wrench and socket wrench set.

27. Position inner transfer shaft (15) and outer transfer shaft (16) in bracket assembly (13). Secure with screw (12) and

new locknut (11). Use cross-tip screwdriver.

28. Attach gauge (11) to governor (12) in adjusting position. Secure with two screws (13). Align hole in throttle arm (14)

with hole in gauge. Secure throttle arm.

29. Remove two screws (13) and gauge (11) from governor (12). Install gauge in operating position on governor. Secure

with two screws.

0021 00-24