TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 195 of 785

TM 9-2350-261-34

REPLACE ENGINE — Continued

0021 00

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

13. Apply a thin, even coat of primer and then sealing compound to cleaned external pipe threads of elbows (11), nipple

(12), tee (13), elbow (14), and elbow (15). Do not apply primer or sealant beyond small end of threads.

14. Install two elbows (11) in engine block.

15. Connect two engine oil filter hoses (16) to two elbows (11).

16. Install oil cooler nipple (12) in engine oil cooler housing.

17. Connect tee (13) with elbow (14) to oil cooler housing nipple (12).

18. Install transmission oil temperature sending unit (17) to tee (13). TIGHTEN OIL TEMPERATURE SENDING UNIT

TO 240 -3 00

LB

-

IN

(2 7-34 N ·M) TO R QUE. U se torque wrench.

19. Install elbow (15) in engine oil cooler housing.

20. Connect two transmission oil hoses (18) to two elbows (15) and (14).

0021 00-22