TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 310 of 785

TM 9-2350-261-34

REPAIR TRACK TENSION ADJUSTER — Continued

0037 00

ASSEMBLY

1.

If removed, press new sleeve bushing (14) in cylinder (3) from side opposite lubrication fitting (9). Use arbor press.

2.

If removed, press new sleeve bushing (15) into plunger (2). Use arbor press.

NOTE

Install new packings (13) with sealing lips facing away from flange on piston (10). Lips face

inside of cylinder.

3.

Install five new packings (13), new bearing (12), and new retaining ring (11) on piston assembly (10).

4.

Applyalightcoatofengineoiltopistonassembly(10)andtoinsideofcylinder(3).

5.

Install piston assembly (10) in cylinder (3).

6.

Install new retaining ring (8) in cylinder (3). Make sure it seats in groove.

7.

Install new bearing (7) in cylinder (3).

NOTE

Install new wiper ring (5) with grooved edge facing out of cylinder toward retaining ring.

8.

Install new packing (6), new wiper ring (5), and new retaining ring (4) in cylinder (3).

9.

Apply a light coat of lubricating oil to plunger (2).

10. Install plunger (2) in cylinder (3). Maintain inward pressure on plunger and rotate clockwise until secure.

11. Install bleeder valve (1) and lubrication fitting (9) in cylinder (3).

003700-3