TM-9-2350-261-34
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
TM-9-2350-261-34 - Page 38 of 785
TM 9-2350-261-34
INTRODUCTION HOW TO USE TROUBLESHOOTING — Continued
0005 00
Legend to Sample
1TITLE
This is the name of the procedure.
2 INITIAL SETUP
This tells you the tools, materials/parts, personnel, references, and equipment
conditions needed to do the procedure.
3TASKSTEPS
These boxes give you step-by-step instructions.
4 REFERENCE LETTER
This will send you to the correct block to continue with the
troubleshooting procedure.
5 QUESTIONS
This is the last step in YES blocks. The answer to this question will
direct you to the next block.
6 ILLUSTRATIONS
These help you locate and identify parts.
Locating the Correct Troubleshooting Procedure
(1) Component/carrier arrives at shop.
(2) Read DA Form 2404.
(3) Verify that the problem on DA Form 2404 exists.
(4) Look up carrier symptom in Fault Symptom Index and go to that task.
Perform the Troubleshooting Procedure
(1) Make sure you have all items in INITIAL SETUP.
(2 )
P erform req uired action(s) in Equ ipm ent C o nditio n.
(3) Complete first block of task steps.
(4) Refer to system schematic or diagram for system components, detail, and clarification.
(5) Answer question at the bottom of the first block.
(6) Follow YES or NO arrows to next block.
(7) Move from block to block. Answer questions and follow instructions. You may be directed to: do further checks
and tests on parts; go to another manual and do tasks; or go to another task.
NOTE
After completing the actions called for on another page or manual, return to the point in the
troubleshooting procedure where you left off.
(8) Locate fault and perform corrective action.
(9) Check to make sure the fault is corrected, and there are no new faults.
(10) Button up by installing items listed in Equipment Conditions after finishing the troubleshooting task.
000500-3
Back to Top
