TM-9-2350-261-34

TM-9-2350-261-34 - Page 40 of 785

TM 9-2350-261-34

INTRODUCTION HOW TO USE TROUBLESHOOTING — Continued

0005 00

Check title to make sure you are troubleshooting the correct system or component for the problem. Next, read the INITIAL

SETUP carefully. Make sure you have all the items listed in INITIAL SETUP. Some access steps in Equipment Conditions

may not need to be performed depending on fault location. It’s up to you to decide which are necessary for your particular

problem.

Now you’re ready to begin troubleshooting. Look at the first block. Read Step 1. If the answer to the question “Is there

output from EXTERNAL BINDING POSTS sockets?” is YES, follow the YES arrow to the next box. Read Step 1 in that

box. If the answer to the question "Is there output from TENT INTERFACE PANEL sockets?” is YES, follow the YES arrow

to the next box. Follow the same procedure for each box. If you reach the second to last box on the page and the answer to

the question “Is there output from RF jacks J119, J120, J121, and/or J122?” is NO, follow the NO arrow to reference GY.

Then go to the page indicated.

000500-5