TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 612 of 785

REPLACE/REPAIR INVERTER AND INVERTER HOUSING ASSEMBLY

A2 (M1068 ONLY) — Continued

NOTE

Before installation of inverters IN1 and IN2, shut POWER switches OFF. The cascade remote

harness W15 will control inverters.

Installation for inverters IN1 and IN2 are different. Follow schematic for proper wiring

connections.

7.

Connect two cable W15 connectors (19) to inverter IN1 (20) and inverter IN2 (21).

8.

Install blackout curtain (17) on inverter housing (18) and secure with six washers (16), three screws (14), and new

locknuts (15).

9.

Install two ground leads E5 (13) on carrier wall and secure with new lockwasher (12) and screw (9).

10. Install ground lead W432 (11) and ground lead W632 (10) on carrier wall and secure with new lockwasher (12) and

screw (9).

11. Connect cable W6 (6) and two leads E4 (7) on terminal block TB1 (8) and secure with two set screws (5).

12. Connect cable W5 (3) and six leads (2) on terminal block TB2 (4) and secure with ten screws (1).

007900-5

0079 00

TM 9-2350-261-34