TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 762 of 785

TM 9-2350-261-34

FABRICATED TOOLS

0106 00

SCOPE

This work package includes instructions for making tools authorized to be fabricated at DS or GS maintenance levels. These

tools are needed for special maintenance procedures, but are not available in the supply system. The tools are normally

fabricated locally when required by the troubleshooting or maintenance task.

FABRICATION INSTRUCTIONS

The following figures provide tool fabrication instructions. All parts and bulk materials needed for manufacturing the tool are

listed on each figure. When needed, any special explanatory instructions are included in the notes on the figure.

Lockring Drive Tool for Stud Insert

MATERIALS/PARTS REQUIRED

Round steel stock 1020 or 1040, or locally procured steel pipe.

NOTES

1. Remove all burrs.

2. Do not break sharp edges.

3. All dimensions are in inches.

010600-1