TM-9-2350-273-BD

M48/M60 SERIES TANK, COMBAT FULL-TRACKED 105-MM GUN

TECHNICAL MANUAL; OPERATORS, ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; BATTLEFIELD DAMAGE ASSESSMENT AND REPAIR

TM-9-2350-273-BD - Page 212 of 288

NOTE

c

D

E

F

G

H

I

J

K

L

TM 9-2350-273-BD

COMMUNICATIONS SYSTEM

BUT

if the CALL light does not come on, the switch is in NORMAL.

Organizational or higher maintenance should then:

Remove R/T from mount, turn R/T upside down.

Remove bottom cover from R/T.

Loosen assembly A4000 captive screws.

Raise assembly A4000 and lock brace.

Turn X-MODE-NORMAL switch to X-MODE.

Be sure leaf springs are equally curved.

Lower assembly A4000 and tighten captive screws.

Be sure assembly hinge pin is pushed all the way in.

Replace bottom cover of R/T.

Replace R/T on to mount.

If the AUX receiver is to be used in the X-MODE communications hookup it

must be opened up and its switch set to X-MODE.

. .

The AUX receiver switch must be placed in NORMAL after you are through with

the X-MODE hook-up.

#10 - Loss of automatic channel selection if RT-246 is being used.

11-57