TM-9-2350-277-20-1

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 1 OF 6

TM-9-2350-277-20-1 - Page 300 of 855

TM 9-2350-277-20-1

COOLANT TEMP INDICATOR MALFUNCTIONS

0053 00

INITIAL SETUP:

Maintenance Level

Unit

Tools and Special Tools

General Mechanic’s Tool Kit (WP 0926 00, Item 65)

Multimeter (WP 0926 00, Item 30)

Jumper Wire

Personnel Required

Mechanic

References

TM 9-2350-277-10

Equipment Condition

Engine stopped (TM 9-2350-277-10)

Carrier blocked (TM 9-2350-277-10)

Power plant access door open (TM 9-2350-277-10)

Driver’s power plant access panel removed

(WP 0441 00)

Power plant rear access panels removed (WP 0439 00)

T

1.

Remove harness 12349873 circuit 33 plug (1) from water

temperature transmitter jack (2).

2.

Turn MASTER SWITCH to ON. See TM 9-2350-277-10.

3.

Is TEMP indicator needle in full left (cold) position?

GO TO

AY

(PAGE 0053 00-2)

Y

1.

Turn MASTER SWITCH to OFF.

2.

Install jumper wire between harness 12349873 circuit

33 plug and ground.

3.

Observe TEMP indicator needle.

4.

Turn MASTER SWITCH to ON for two seconds.

5.

Did TEMP indicator needle move to full right (hot) position?

GO TO

BY

(PAGE 0053 00-3)

005300-1

Change 5

TN

YN