TM 9-2350-277-20-3
REPLACE STEERING LOCK SWITCH WIRING HARNESS (M58 ONLY)
0367 01
THIS WORK PACKAGE COVERS:
Removal (page 0367 01-1).
Inspect and Repair (page 0367 01-2).
Installation (page 0367 01-2).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Multimeter (WP 0926 00, Item 30)
Materials/Parts
Grommet
Locknut (3)
Strap
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Battery ground strap disconnected (WP 0337 00),
(WP 0338 00), or (WP 0339 00)
REMOVAL
1.
Disconnect circuit leads 369 and 369A (used on solenoid-activated lock) or leads 369A and 368 (used on cable-activated
lock) (1) and (2) from steering locked indicator switch (3).
NOTE
Do Step 2 for solenoid-activated lock only.
2.
Remove two nuts (8), lockwashers (7), circuit 368A lead (5), and ground lead (6) from solenoid terminals (4). Do not
discard lockwashers.
3.
Remove strap (9) securing wiring harness (10) in the steering wheel housing.
0367 01-1
Change 1