TM-9-2350-277-20-4

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 4 OF 6

TM-9-2350-277-20-4 - Page 278 of 861

TM 9-2350-277-20-4

REPLACE CARGO HATCH COVER (M113A3

AND M1059A3 ONLY) —

Continued

0479 00

INSTALLATION

1.

Install screw (1) in cover (2). Secure with new locknut (3).

2.

Place shim(s) (4) and bracket (5) on hull top plate. Secure with two washers (6) and screws (7). TIGHTEN SCREWS

TO 60-65 LB-FT (81-88 N•m) TORQUE.

3.

Align cover (2) with hinge brackets. Install two ﬁber washers (8) and shield (9).

4.

Apply coat of grease to each spring (10). Install 10 springs in shield (9).

5.

Place cover (2) in vertical position. Install shim(s) (11) and bracket (12). Secure with two washers (13) and screws (14).

TIGHTEN SCREWS TO 60-65 LB-FT (81-88 N•m) TORQUE.

FOLLOW-THROUGH STEPS

1.

Install cargo hatch interior latch (WP 0475 00).

2.

Install cargo hatch spall liner (M113A3 only) (WP 0509 00).

3.

Adjust latch (WP 0475 00).

4.

Close cover. Check that cargo hatch cover is installed correctly.

END OF TASK

0479 00-3/4 blank

Change 2