TM-9-2350-277-20-4
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 4 OF 6
TM-9-2350-277-20-4 - Page 28 of 861
TM 9-2350-277-20-4
REPLACE TORSION BAR — Continued
0413 00
NOTE
Screw is installed with head inside adapter.
5.
Thread adapter on puller, then thread adapter with screw into torsion bar.
CAUTION
When removing or installing torsion bars, the index or missing tooth on the anchor end of
torsion bar must align with index on spline in road wheel arm, to allow bar to pass through.
6.
Pull torsion bar (3) from torsion bar anchor (4). Use slide hammer on puller.
7.
Remove puller and adapter from torsion bar.
8.
If torsion bar (3) is broken, remove as follows:
a.
Remove road wheel end of torsion bar in the same way as unbroken torsion bar.
b.
Pull or drive end of broken bar from its splined seat in torsion bar anchor (4).
0413 00-3
Change 3
Back to Top
