TM-9-2520-215-34
CROSS-DRIVE TRANSMISSION ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 2005
TM-9-2520-215-34 - Page 16 of 508
TM 9--2520--215--34
0001 00--4
GENERAL INFORMATION – CONTINUED
0001 00
LIST OF ABBREVIATIONS -- Continued
FT
Foot/Feet
LB -- IN
Pounds--Inches
BORE O.D.
Bore Outer Diameter
BORE I.D.
Bore Inner Diameter
MIN
Minimum
UNC
Unified Coarse
UNF
Unified Fine
QUALITY ASSURANCE (QA)
No particular quality assurance manual pertains specifically to the XT--1410--4 Cross--Drive Transmission.
Defective material received through the supply system should be reported on Quality Deficiency Report (QDR) SF
368.
Instructions for preparing QDRs are provided in AR 702--7, Reporting of Quality Deficiency Data. QDRs should be
mailed directly to:
Commander
US Army Tank--automotive and Armament Command
ATTN: AMSTA QTR
Warren, MI 48397--5000
A reply will be furnished directly to you.
COMMON TOOLS AND EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE),
CTA 50--970 or CTA 8--100, as applicable to your unit.
The tool kit (box) assigned to the mechanic (on a 1 per mechanic--by--MOS basis) shall be identified in the individual
maintenance paragraphs by nomenclature, item number, and work package. No tool in the kit shall be further identi-
fied. Other tools required for performance of all tasks for the maintenance levels covered in the manual shall be iden-
tified in the setup and shall be referenced to the Tool Identification List, WP 0088 00. “Other tools” includes tools
which are part of components of shop sets authorized to sections/teams; tools authorized by RPSTL and CTA
50--970; special and fabricated tools and items of TMDE.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Special tools and equipment listed and illustrated in TM 9--2350--215--34P are the only special tools and equipment
necessary to perform operations described in this manual. TM 9--2350--215--34P is the authority for requisitioning
special tools and equipment for supporting maintenance use. All special tools required in this technical manual are
listed in WP 0088 00 of this manual. Fabricated tools are identified in the initial setup; manufacturing instructions for
fabricated tools are found in WP 0089 00.
REPAIR PARTS
Repair parts are listed and illustrated in the repair parts and special tools list covering Direct Support and General
Support maintenance for this equipment (TM 9--2350--215--34P). All mandatory replacement parts identified in the
initial setup are listed in WP 0087 00 of this manual.
Back to Top
