TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 373 of 508

TM 9--2520--215--34

0072 00--1

LOW RANGE CLUTCH ANCHOR AND RELATED PARTS REPAIR

0072 00

THIS WORK PACKAGE COVERS:

Disassembly, Cleaning, Inspection, Fit and Wear Limits, Assembly

INITIAL SETUP:

Tools and Special Tools

General mechanic’s tool kit (item 1, WP 0088 00)

C--clamp (2) (item 32, WP 0088 00)

Retaining ring pliers (item 21, WP 0088 00)

Torque wrench (item 22, WP 0088 00)

Materials/Parts

Lumber (item 6, WP 0085 00)

Retaining ring (60) (item 25, WP 0087 00)

Equipment Conditions

Low range clutch housing removed (WP 0071 00)

DISASSEMBLY

1. Clamp the low range clutch anchor assembly (1). Remove three screws (2) from low range clutch anchor (3) and

low and reverse range clutch backplate (4).

2. Loosen both clamps at the same time and remove clamps.

3. Turn the low range clutch anchor assembly (1) over and lift off low and reverse range clutch backplate (4).

NOTE

Do not remove 60 snap rings from pins unless replacement is necessary.

4. Remove 30 long clutch release pins (5), 30 springs (6) and 30 short pins (7). Remove 60 snap rings (8). Discard

snap rings.