TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

  TM-9-2520-215-34 - Page 374 of 508

TM 9--2520--215--34
0072 00--2
LOW RANGE CLUTCH ANCHOR AND RELATED PARTS REPAIR –
CONTINUED
0072 00
CLEANING
See WP 0018 00 for cleaning procedures.
INSPECTION
See WP 0018 00 for general inspection and repair recommendations.
FIT AND WEAR LIMITS
Check the following parts to the dimensions listed. Replace if not within the specified dimensions.
PART NAME
CHECK POINTS
ACCEPTABLE LIMITS
Low and reverse range clutch piston release spring
Length of spring
Length under load
3.035 in.
1.58 in. at 28.8 to 35.2 lb
ASSEMBLY
1. Position the low range clutch anchor (3), bolt hole counterbores down, on wooden blocks. Install 30 short clutch
piston release pins (7), 30 new snap rings (8) and 30 springs (6).
2. Install 30 long clutch release pins (5) with 30 snap rings (8) into springs (6). End of springs next to snap rings (8)
must be down.
3. Align external slots in low and reverse range clutch backplate (4) with slots in low range clutch anchor (3) and
install backplate (4) onto long clutch release pins (5).


Back to Top