TM-9-2520-215-34
CROSS-DRIVE TRANSMISSION ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 2005
TM-9-2520-215-34 - Page 81 of 508
TM 9--2520--215--34
VEHICLE STEERS PROPERLY IN ONLY ONE DIRECTION
0015 00
THIS WORK PACKAGE COVERS:
Vehicle Steers Properly in Only One Direction
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0088 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--256--10)
Personnel Required
Two
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Did steer linkage require adjustment?
1. Check steer clutch.
2. Apply pressure on the side which does not
steer properly.
3. Adjust steer linkage if necessary (WP
0082 00).
no
yes
1. If linkage adjustment is correct,
clean or replace faulty steer
valve components in steer
control valve assembly
(WP 0027 00).
2. Remove and repair faulty steer
clutch components in steer
clutch housing assembly (WP
0039 00).
Fault corrected.
A
END OF WORK PACKAGE
0015 00--1/2 blank
Back to Top
