TM-9-2520-215-34
CROSS-DRIVE TRANSMISSION ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 2005
TM-9-2520-215-34 - Page 83 of 508
TM 9--2520--215--34
STEER CLUTCH GRABS
0016 00
THIS WORK PACKAGE COVERS:
Steer Clutch Grabs
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0088 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--256--10)
Personnel Required
Two
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Are brakes properly adjusted?
Check for improperly adjusted brakes (too tight).
no
yes
Adjust brakes (WP
0052 00).
Is steer control linkage properly adjusted?
Check steer control linkage for proper adjustment.
no
yes
A
B
no
yes
Adjust valves and/or clean
or replace faulty valves
(WP 0027 00).
Fault corrected.
Does the steer control valve move freely without sticking?
Check for sticking steer control valve(s).
C
Adjust brakes (WP
0052 00).
END OF WORK PACKAGE
0016 00--1/2 blank
Back to Top
