TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 104 of 319

TM 9-2520-238-34

REPAIR TRANSFER GEARCASES A, B, AND C — Continued

0017 00

NOTE

If needed, remove the following components.

15. Remove two cap screws (16) and cover (17) from housing (12).

16. Remove resilient mount (18) from housing (12) using remover and replacer shown.

17. On gearcase A, B, or C, remove groove pin (19) and manual remote control lever (20) from engine disconnect actuator.

Discard pin.

18. Remove generator drive assembly (21) or generator drive assembly (22). Straighten tabs on four key washers (23).

Remove four cap screws (24) and key washers (23).

19. Remove shim (25) from cover and packing (26) from generator drive (21) or generator drive (22). Discard shim and

packing.

0017 00-6

NOTE

This is an internal gear and is not

removed here.

This is only shown

as a reference for the pump installation.