TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 194 of 319

TM 9-2520-238-34

REPAIR BRAKE SHOE ASSEMBLIES — Continued

0022 00

CLEANING

CLEAN, INSPECT, AND REPAIR

1.

Before inspection, repair, or assembly, clean all parts of each output shaft assembly as described in (WP 0014 00).

2.

Inspect all parts. Refer to (WP 0014 00) for general inspection and repair procedures. Check wear limits and clearances

of parts (page 0022 00-8). Repair or replace defective parts.

3.

Measure springs for free (no tension or compression) length of 3-3/8 to 3-5/8 inches (8.6 to 9.2 cm). Replace any springs

not within these dimensions.

0022 00-4