TM-9-2520-238-34
M113A1 FOV, M113A2 FOV, M548 AND M548A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE
TM-9-2520-238-34 - Page 202 of 319
TM 9-2520-238-34
REPLACE OUTPUT SHAFT ASSEMBLIES — Continued
0023 00
REMOVAL
CAUTION
Provide safe blockage arrangement at work station and place output shaft assemblies in
convenient position for disassembly.
NOTE
Left and right brake adapter are removed and installed in the same manner.
1.
Remove four locknuts (1) and adapter (2) from differential output shaft. Discard locknuts.
0023 00-2
Parts of the brake assembly may be coated with asbestos dust. Breathing this dust can harm
personnel. Use a filter mask approved for use against asbestos dust. Never use compressed air
or dry brush to clean these assemblies. Use an industrial type vacuum cleaner with a
high-efficiency filter system to remove dust. Use water and a soft bristle brush or cloth to
remove dirt or mud.
WARNING
Back to Top
