TM-9-2520-238-34
M113A1 FOV, M113A2 FOV, M548 AND M548A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE
TM-9-2520-238-34 - Page 204 of 319
TM 9-2520-238-34
REPLACE OUTPUT SHAFT ASSEMBLIES — Continued
0023 00
INSTALLATION
1.
Install pipe to tube elbow (10) in left output shaft assembly (7) . Clean threads of elbow thoroughly. Apply a light coat
of sealing compound to threads at installation.
2.
Install left output shaft assembly (7) on right angle gearbox differential (2) . Apply a light coat of antiseize compound to
clean threads of six cap screws (12) . Install piston ring (14) on output shaft of right angle gearbox. Install new gasket
(13) and left output shaft assembly (7) on right angle gearbox with six new key washers (11) and cap screws (12) .
Tighten screws to 55-60 lb-ft (75-81 N•m) torque. Use torque wrench. Bend tabs on key washers.
3.
Install pipe plug (15) in right output shaft assembly (1) . Apply a light coat of antiseize compound to clean threads of
plug. Install plug in right output shaft.
4.
Install right output shaft assembly (1) on differential (2) . Apply a light coat of antiseize compound to clean threads of
six cap screws (4) . Install piston ring (6) on output shaft of differential. Install new laminated shim (5) and right output
shaft assembly (1) on differential with six new key washers (3) and cap screws (4) . Tighten screws to 55-60 lb-ft (75-81
N•.m) torque. Use torque wrench. Bend tabs on key washers.
0023 00-4
Back to Top
