TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 212 of 319

TM 9-2520-238-34

REPAIR OUTPUT SHAFT ASSEMBLIES — Continued

0024 00

11. Remove gasket (11) and oil seal retainer (3) with encased oil seal (12) from output shaft (4). Discard gasket.

12. Tap out oil seal (12) from retainer (3) with hammer. Discard oil seal.

NOTE

If inspection indicates shoulder bolt(s) is damaged, do Step 13.

NOTE

If inspection indicates serrated lockring screw thread insert is damaged, do Step 7.

13. Remove bolt(s) (13) from base of output shaft (4). Use arbor press.

CLEANING

CLEAN, INSPECT, AND REPAIR

1.

Before inspection, repair, or assembly, clean all parts of each output shaft assembly as described in (WP 0014 00).

2.

Inspect all parts using general procedures described in (WP 0014 00). Check wear limits for minimum, maximum, and

important clearances of new or rebuilt parts (page 0023 00-13).

0024 00-6