TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 214 of 319

TM 9-2520-238-34

REPAIR OUTPUT SHAFT ASSEMBLIES — Continued

0024 00

CAUTION

To prevent damage to encased oil seal, do not press seal beyond face of bore. After installation,

seal must be ﬂush with outer surface.

6.

Install oil seal (1) in oil seal retainer (2). Use remover and replacer (WP 0033 00, Item 24) and hammer.

NOTE

If shoulder bolt(s) was removed in page 0024 00-2, do Step 7.

7.

Install new bolt(s) (3) in base of shaft (4) with ﬂat side of bolts toward shoulder. Use arbor press.

8.

Install new piston ring (5) on piston ring retainer (6).

9.

Install oil seal retainer (2) with oil seal (1) installed, new gasket (7), ball bearing (8), and retainer (6) with piston ring (5)

on shaft (4). Use remover and replacer (WP 0033 00, Item 20) and arbor press.

0024 00-8