TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 216 of 319

TM 9-2520-238-34

REPAIR OUTPUT SHAFT ASSEMBLIES — Continued

0024 00

NOTE

Steps 14 - 23 apply to left output shaft assembly.

If serrated lockring screw thread insert was removed in page 0024 00-2, do Steps 1 - 3.

14. Thoroughly clean mating surface of new encased oil seal (1) with cleaning compound.

15. Apply thin ﬁlm of sealing compound to outer edge of oil seal (1).

CAUTION

To prevent damage to encased oil seal, do not press seal beyond face of bore. After installation,

seal must be ﬂush with outer surface.

16. Install oil seal (1) in oil seal retainer (2). Use remover and replacer (WP 0033 00, Item 24) and hammer.

0024 00-10