TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 215 of 319

TM 9-2520-238-34

REPAIR OUTPUT SHAFT ASSEMBLIES — Continued

0024 00

10. Install new key washer (9) and retaining nut (10) on shaft (4). Tighten nut. Bend tabs on key washer (9) over nut.

11. Thoroughly clean threads of four cap screws (11).

12. Apply light coat of antiseize compound to threads of cap screws (11).

13. Install retainer (6) with attached parts on output shaft support (12) with four new key washers (13) and cap screws (11).

Tighten screws to 252-300 lb-in (28.5-33.9 N•m) torque. Use torque wrench and socket wrench set. Bend tabs on key

washers.

0024 00-9