TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 217 of 319

TM 9-2520-238-34

REPAIR OUTPUT SHAFT ASSEMBLIES — Continued

0024 00

NOTE

If shoulder bolt(s) was removed in page 0024 00-2, do Step 17.

17. Install shoulder bolt(s) (3) in base of shaft (4) with ﬂat side of bolt(s) toward shoulder. Use arbor press.

18. Install new piston ring (5) on piston ring retainer (6).

19. Install retainer (2) with oil seal (1) installed, new gasket (8), ball bearing (7), and retainer (6) with piston ring (5) on shaft

(4). Use remover and replacer (WP 0033 00, Item 20) and arbor press.

20. Install new key washer (9) and retaining nut (10) on shaft (4). Tighten nut. Bend key washer tabs on nut.

0024 00-11