TM-9-2520-238-34
M113A1 FOV, M113A2 FOV, M548 AND M548A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE
TM-9-2520-238-34 - Page 92 of 319
TM 9-2520-238-34
REPAIR COOLING FAN RIGHT ANGLE DRIVE C (M113A3 FOV ONLY) — Continued
0016 00
16. Install bearing retainer plate (5) on housing (12) as follows:
a.
Apply a coat of antiseize compound to threads of four bolts (13).
b.
Install bearing retaining plate (5) and oil seal retainer (10) on housing (12) and secure with four washers (14) and
bolts (13).
c.
Tighten four bolts (13) to 194-228 lb-in (22-25 N•m) torque. Use torque wrench (WP 0033 00, Item 41) and socket
set.
17. Lubricate new packing (15) with grease or petrolatum. Install packing in groove on cartridge assembly (16).
18. Lubricate new packing (17) with grease or petrolatum. Install packing in groove on oil seal retainer (11).
NOTE
Install cartridge assembly with the word TOP facing up.
19. Install cartridge assembly (16) on housing (12) as follows:
a.
Apply a coat of antiseize compound to threads of four bolts (18).
b.
Install peeled shim (19), cartridge assembly (16), and oil seal retainer (11) on housing (12) and secure with four
washers (20) and bolts (18).
c.
Tighten four bolts (18) to 194-228 lb-in (22-25 N•m) torque. Use torque wrench (WP 0033 00, Item 41) and socket
set.
20. Install copper washer (21) and screw (22) in drain hole in housing (12).
0016 00-14
Back to Top
