TM-9-2520-246-34-1

TRANSMISSION MODEL 3053A; TRANSMISSION TRANSFERS MODEL T-136-21 AND MODEL T-136-27; POWER TAKEOFFS MODEL WN-7-28, MODEL WND-7-28 AND MODEL P-136-C

TECHNICAL MANUAL; MAINTENANCE, DIRECT SUPPORT AND GENERAL SUPPORT LEVEL

JANUARY 1981

TM-9-2520-246-34-1 - Page 384 of 418

TM 9-2520-246-34-1

2-38. ASSEMBLY. This paragraph gives instructions for putting the transmission

transfer power takeoff together and also has end play adjustment needed.

NOTE

Keep all parts clean and protected from dust and dirt.

Coat all bearings with multipurpose lubricant during

assembly. Coat oil seal, gear and shafts with engine

lubricating oil during assembly. Coat shafts and

bore of gear with white lead pigment during assembly.

Use new seal and gasket during assembly.

FRAME 1

1.

Put in key (1).

2.

Put bearing cone (2) and shaft (3) in hydraulic press as shown.

NOTE

Make sure that tapered end of bearing cone (2) is facing splined

end of shaft (3).

3.

Press shaft (3) into bearing cone (2).

GO TO FRAME 2

2-364