TM-9-2520-246-34
TRANSMISSION MODEL 3052, NSN 2520-00-347-4520
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
MAY 1978
TM-9-2520-246-34 - Page 35 of 153
TM 9-2520-246-34
interruptions.
ICE, MIL-L-2104. Allow the seal to soak for 45 minutes
before installation.
(4) When preparing a new oil seal for assembly,
place it in a small container of lube oil (OE/HDO 10)
2-11. Lubrication.
Refer to LO 9-2320-209-12/1 for
lubrication instructions.
Section IV. REMOVAL AND INSTALLATION OF
MAJOR COMPONENTS AND ASSEMBLIES
2-12. General.
This section provides procedures for
the removal and installation of the following major
components and assemblies: transmission, transfer,
and power takeoff assemblies.
2-13. Transmissions, Models 3052 and 3053A.
Refer to TM 9-2320-209-34 for multifuel engine
powered vehicles or TM 9-2320-209-20 for gasoline
powered vehicles.
2-18
2-14. Transfer, Models T-136-21 and T-136-27.
Refer to TM 9-2320-209-34 for multifuel engine
powered vehicles or TM 9-2320-209-20 for gasoline
engine powered vehicles.
2-15. Power Takeoffs, Models WN-7-28, WND-
7-28, and P-136-C.
Refer to TM 9-2320-209-34 for
multifuel engine powered vehicles or TM 9-2320-209-
20 for gasoline engine powered vehicles.
Back to Top
