TM-9-2520-246-34
TRANSMISSION MODEL 3052, NSN 2520-00-347-4520
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
MAY 1978
TM-9-2520-246-34 - Page 85 of 153
TM 9-2520-246-34
rear bearing cover capscrews to 60-77 lb-ft
torque. Refer to section VII of this chapter
for bearing adjustment procedures.
Remove the four capscrews and lockwashers
securing the idler shaft rear bearing cover to the
transfer case. (See fig. 4-35.) Remove the cover and
rear bearing shims.
o. Input Shaft Rear Bearing Cover.
Figure 4-34. Removal of Transfer Top Cover
and Shifter Shaft.
n. Idler Shaft Rear Bearing Cover.
NOTE
During assembly, tighten the idler shaft
NOTE
During assembly, use a new gasket. Tighten
capscrews to 60-77 lb-ft torque.
NOTE
Remove the six capscrews and lockwashers
securing the input shaft rear bearing cover
to the transfer case. (See fig. 4-35.) Remove
the rear bearing cover and gasket; discard
the gasket.
Figure 4-35. Removal of Rear Output Shaft Rear Bearing Cover, Idler Shaft Rear Bearing
Cover, and Input Shaft Rear Bearing Cover.
4-24
Back to Top
