TM-9-2520-246-34
TRANSMISSION MODEL 3052, NSN 2520-00-347-4520
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
MAY 1978
TM-9-2520-246-34 - Page 90 of 153
TM 9-2520-246-34
Figure 4-43. Front Output Shaft Cover —
Disassembly.
(3) Remove the handbrake shoe lever and lever
pins. (See fig. 4-45.)
Replacement brakeshoes must be drilled for
rivet holes. Be sure to wear a mask to
prevent asbestos dust particles from
entering the lungs. Drilling must be done in
a well-ventilated area away from
unprotected personnel. Eyeglasses must
also be worn during drilling operation.
Failure to observe these precautions may
result in injury to personnel.
(4) Remove the 16 rivets securing the inner and
outer brakeshoes to the handbrake assembly. (See fig.
4-45.)
4-24. Assembly of Subassemblies.
a.
b.
c.
d.
Handbrake (fig. 4-45).
Transfer case (fig. 4-44).
Front output shaft cover (fig. 4-43).
Transfer case cover (figs. 4-41, 4-42).
Figure 4-44. Transfer Case — Disassembly.
e.
Sprag units (fig. 4-40).
f.
Front output shaft (fig. 4-39).
g.
Input shaft assembly (fig. 4-38).
h.
Idler shaft assembly (fig. 4-37).
i.
Rear output shaft assembly (fig. 4-36).
Figure 4-45. Handbrake Shoe — Disassembly.
4-29
Back to Top
