TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 163 of 488

TM 9-2520-272-34&P

4-19.

DISASSEMBLE RIGHT END COVER ASSEMBLY

(SHEET 2 OF 16)

WARNING

o

Check slings and lifting devices for cuts, breaks, or wear before hoisting end cover assembly and

during hoisting.

Slings and lifting devices can break and cause injury or death.

o

Right end cover weighs approximately 125 pounds (57.1 kg).

When lifting end cover, a hoist must be

used to avoid bodily injury.

TASK 1.

REMOVE COOLER LINE ELBOW, CONNECTOR, AND RH OUTPUT FLANGE

COMMON TOOLS:

Bar, pry

Chisel, cold

Crowfoot, 1/2 inch square drive, 2 inches

Hammer, hand, ball peen

Handle, socket wrench, 1/2 inch square drive

Handle, socket wrench, 3/4 inch square drive

Socket, socket wrench, 1/2 inch square drive,

3/4 inch

Socket, socket wrench, 3/4 inch square drive, 1-

7/8 inches

Wrench, combination, 1-7/8 inches

Wrench, combination, 15/8 inches

SUPPLIES:

Bolt, 1/2-20 x 3 inch (2 required)

Rag, wiping (Item 15, Appendix C)

NOTE

Right end cover assembly turned outside up.

1

Using 17/8 inch combination wrench to hold

connector (adapter) (1), use 2 inch crowfoot and

handle to remove elbow (2) from connector

(adapter) (1).

2

Using 1-7/8 inch socket and handle, remove

connector (adapter) (1) and packing (3) from

right end cover assembly (4).

Remove o-ring (3)

from elbow (adapter) (1).

Throw away o-ring.

3

Using chisel and hammer, straighten bent tab of

washer (5) Bend tab away from bolt (6).

4

Using 3/4 inch socket, install two 1/2-20 x 3 inch

bolts (7)

in tapped holes at either end of

output flange (8).

5

Using one hand, hold pry bar between two bolts

(7) to prevent flange (8) from turning.

Go to Sheet 3

Para 4-19, Task 1

Change 2

4-97