TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 153 of 488

TM 9-2520-272-34&P

4-18.

INSTALL TRANSMISSION TOP COMPONNEMTS

(SHEET 8 OF 16)

TASK 4. INSTALL PRIORITY VALVE ASSEMBLY

COMMON TOOLS:

Extension, socket wrench, 1/2 inch square drive, 6 inch

Handle, socket wrench, 1/2 inch square drive

Socket, socket wrench, 1/2 inch square drive, 7/16 inch

Wrench, torque, 0-175 ft-lb

SUPPLIES:

Cloth, batiste, lint-free (Item 6, Appendix C)

PRELIMINARY PROCEDURE:

Separator plate is installed on transmission. Refer to this

paragraph, TASK 1.

CAUTION

Transmission must be in upright position when oil transfer gasket, oil transfer

plate, separator plate, and control valve assemblies are installed. If

transmission is not in vertical position when these items are installed,

misalignment of holes can block oil flow, causing malfunction of transmission.

Care should be taken not to let dust get into control valve assemblies. Keep

top of transmission center housing clean.

Keep all parts clean. Wipe with

lint-free cloth. Contamination of control valves can cause transmission

failure.

1 Using socket, install two 1/4-18 x 2-1/8 inch bolts (1)

and washers (2) holding priority valve (3) to separator

plate (4).

End of Task 4

Go to Sheet 9

Para. 4-18, Task 4

4-87