TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 145 of 488

TM 9-2520-272-34&P

4-17.

REMOVE TRANSMISSION FROM MAINTENANCE STAND

(SHEET 7 OF 7)

TASK 2. REMOVE ADAPTER PLATE FROM MAINTENANCE STAND

COMMON TOOLS:

Handle, socket wrench 1/2 inch square drive

Hoist, 200-pound minimum capacity

Socket, socket wrench, 1/2 inch square drive, 7/8 inch

SPECIAL TOOLS:

Eyebolt, (73342) MS51937-5, from Adapter Plate Kit (73342) 11650180

Sling, two-leg (19207) 12268037

PRELIMINARY PROCEDURE:

Transmission is removed from adapter plate. Refer to

this paragraph TASK 1.

WARNING

•

Check slings and lifting devices for cuts, breaks, or wear before hoisting

adapter plate and during hoisting. Slings and lifting devices can break and

cause injury or death

•

Adapter plate weighs 127 pounds. Lift adapter plate with hoist to avoid bodily

injury.

1 Install eyebolt (1) in threaded hole at end of adapter

plate.

NOTE

Only one leg of two-leg sling is used in this

task.

2 Attach sling hook in eyebolt (1) and raise sling until

cable is tight.

3 Using socket, remove six 5/8-11 x 3 inch bolts (2) and

washers (3) from maintenance stand.

4 Remove adapter plate.

5 Remove sling.

6 Remove eyebolt (1).

End of Task 2

Para. 4-17, Task 2

4-79