TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 151 of 488

TM-2520-272-34&P

4-18.

INSTALL TRANSMISSION TOP COMPONENTS

(SHEET 6 OF 16)

3 Install harness connector body (3) into transmission center housing hole (4) with key (6) in

receptacle (7) located at bottom.

4 Using screwdriver, install four No. 4-40 x 7/16 inch screws (8) holding harness connector

body (3) and gasket (1) to transmission. Do not tighten screws.

5 Using socket, adapter and torque wrench, tighten screws (8) to 3-5 lb-in (0.3-0.6 N•m).

FOLLOW-ON PROCEDURE:

Connect harness to solenoids and attach harness ground

connector. Refer to this paragraph TASK 7.

End of Task 2

Go to Sheet 7

Para. 4-18, Task 2

4-85