TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 180 of 488

TM 9-2520-272-34&P

4-20.

REPAIR RIGHT END COVER COMPONENTS

(SHEET 3

OF

14)

SUPPLIES:

Rag, wiping (Item 15, Appendix C)

PRELIMINARY PROCEDURE:

Inner brake adjusting

4-19.

Remove Pin

1 Place inner brake adjusting 1 ink (1) in vise.

2 Using hammer and punch, drive pin (2) from link (1).

Install Pin

3 Using hammer and punch install new pin (2) to a

height of 0.118-0.138 inch (3.00-3.50 mm) above

surface of link (1).

4 Remove link (1) from vise.

FOLLOW-ON PROCEDURE:

Install inner brake

adjusting link. Refer to paragraph 4-21.

End of Task 2

link is remov ed. Refer to paragraph

TASK. 3. REPAIR LEFT BRAKE APPLY SHAFT ASSEMBLY

COMMON TOOLS:

Gage, vernier caliper

Hammer, hand, ball peen

Punch drive pin, 1/16 inch point

REPAIR PARTS:

Pin, spring (24617) 9421003

PRELIMINARY PROCEDURE:

Remove left brake

apply shaft.

Refer to paragraph 4-19.

1 Using

brake

punch and hammer, remove pin (1) from left

apply shaft (2).

2 Using

(2) to

below outside surface of shaft.

punch and hammer, install new pin (1) in shaft

a depth of 0.027-0.047 inch (0.68-1.19 mm)

Go to Sheet 4

4-114

Para. 4-20, Task 3