TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 214 of 488

TM 9-2520-272-34&P

4-22.

DISASSEMBLE LEFT END COVER ASSEMBLY

(SHEET 1 OF 4)

Task

Title

Page

1

2

3

Remove LH Output Flange

4-148

Remove LH Output Shaft and Seal

4-149

Remove Range Input Driven Gear Race, Range Input Drive

Gear Bearing and Oil Transfer Tube Seal Rings

4-151

WARNING

ž

Check slings and lifting devices for cuts, breaks, or wear before and during

hoisting. Slings and lifting devices can break and cause injury or death.

•

Left end cover weighs approximately 90 pounds (41 kg). When lifting end

cover, use hoist to avoid bodily injury.

TASK 1. REMOVE LH OUTPUT FLANGE

COMMON TOOLS:

Bar, pry

Chisel, cold

Extension, socket wrench 1/2 inch square drive, 10 inch

Hammer, hand, ball peen

Handle, socket wrench 1/2 inch square drive

Socket, socket wrench, 1/2 inch square drive, 9/16 inch

Socket, socket wrench 1/2 inch square drive, 3/4 inch

SUPPLIES:

Bolt, 1/2-20 x 3 inch (2 required)

Rag, wiping (Item 15, Appendix C)

PERSONNEL REQUIRED:

T

W O

•

One soldier to hold left end cover on end.

•

One soldier to perform maintenance procedure.

NOTE

One soldier hold left end cover on edge.

Go to Sheet 2

4-148

Para. 4-22, Task 1