TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 216 of 488

•

Left end cover is turned inside up when not

held on edge.

•

End cover leveled by two wooden blocks on

edge positioned under corner nearest to

output shaft.

1

Using screwdrivers, remove retaining ring (1)

retaining bearing assembly (2) and LH output

shaft (3).

2

One soldier hold left end cover (4) on edge to

allow access to exterior.

3

Other soldier locate drift on inside of end of LH

output shaft (3); using hammer and drift, drive

shaft from end cover (4).

NOTE

Second soldier may be dismissed.

4

Place end cover (4) on wooden blocks, inside

up.

5

Using hammer and punch, drive output shaft

seal (5) from left end cover (4).

6

Remove two seal rings (6) from shaft (3).

NOTE

When bearing is removed from shaft,

sleeve is forced off ahead of bearing.

7

If bearing (2) and sleeve (7) is to be replaced,

press bearing (2) and sleeve (7) from output

shaft (3) using an arbor press.

8

X200-4A Remove preformed packing (9) from

end of shaft.

Throw away packing.

FOLLOW-ON PROCEDURE

: Install output shaft packing

and seal.

Refer to paragraph 4-24.

End of Task 2

Go to Sheet 4

4-150

Change 2

Para. 4-22, Task 2