TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 225 of 488

TM 9-2520-272-34&P

4-24.

ASSEMBLE LEFT END COVER ASSEMBLY

(SHEET 5 OF 5)

PRELIMNARY PROCEDURE:

LH output shaft and seal

is installed. Refer to this paragraph TASK 2.

1

2

3

4

5

Instail output flange (1) in LH output shaft (2) located

in left end cover (3).

Install new tab washer (4) on 1/2-20 x 3-1/4 inch bolt

(5) with bent tab on washer toward head of bolt.

Install boIt (5) through center of flange (1) and into

center of output shaft (2). Install bolt finger tight.

Using 3/4 inch socket, install two 1/2-20 x 3 inch bolts

(6) in tapped holes at either end of output flange (1)

until bolts are flush with inner surface of flange.

Using one hand, hold pry bar between two bolts (6) to

prevent flange (1) from turning.

CAUTION

Do not install washer so that tab is over

dimple in flange. To prevent bolt from

turning, tab must be against flat of bolt and

wash e

r

must be dimpled into flange dimple

hole. When tab of washer is at dimple hole,

wash e

r

cannot be dimpled. Bolt retaining

flange to output shaft may then loosen.

6

Using 3/4 inch socket with other hand, tighten bolt (5).

7 Using torque wrench tighten bolt (5) to 72-86 lb-ft

(98-117 N•m).

8 Using 3/4 inch socket, remov

e

two bolts (6) from

flange (1).

NOTE

Do not bend the tab of washer (4) against

flat of bolt (5) at this time.

9 Using punch and hammer, punch dimple in washer (4).

Dimple must depress washer into dimple hole in flange

(1).

FOLLOW-ON PROCEDURE: Install left end cover

assembly. Refer to paragraph 4-15.

End of Task 3

Para, 4-24, Task 3

4-159