TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 290 of 488

TM 9-2520-272-34&P

4-30.

ASSEMBLE CENTER HOUSING

(SHEET 3 OF 20

1 Install new packings (1, 2) onto first clutch Piston (3).

Coat packings (1, 2) with petrolatum.

2 Install piston and sea

center housing.

assembly sleeve 12268021 into

3 Mark outer piston face with felt tip marker across

from tang. Mark range bore above slot in center

housing. This will assist in properly locating piston (3)

in center housing.

4 Using two pairs of slip joint pliers, grasp cross

members on first clutch piston (3) at two points, 180

degrees apart and install piston (3) into center

housing. Index the tang on piston with the slot in

center housing.

5 Remove sleeve 12268021.

6 Install twenty-six springs (4) into spring pockets in

piston (3).

7 Install spring retainer (5) over springs (4). Be sure

twenty-six springs (4) are seated in retainer (5).

Go to Sheet 4

4-224

Para. 4-30, Task 2