TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 295 of 488

TM 9-2520-272-34&P

4-30. ASSEMBLE CENTER HOUSING

(SHEET 8 OF 21)

38 Using marker, mark edge of third clutch piston housing

assembly (26) above bolt hole

39

40

41

42

43

Install third clutch piston housing assembly (26),

aligning bolt hole in piston housing assembly (26) with

bolt hole in center housing.

Using 9/16 inch socket and extension, install washer

(27) and bolt (28) through center housing and into

piston housing assembly (26) finger tight.

Using feeler gage, measure space between piston

housing assembly (26) and to of retaining ring groove

in range pack bore of center housing. Select retaininq

ring (29) from table.

For Measured Distance

0.149-0.152 inch

(3.79-3.88 mm)

0.153-0.155 inch

(3.89-3.96 mm)

0.156-0.158 inch

(3.97-4.03 mm)

0.159-0.161 inch

(4.04408 mm)

Select Ring

6884274

6884273

6884275

6884276

Using screwdriver, install selected retaining ring (29).

Using torque wrench, tighten bolt (28) to 36-43 lb-ft

(49-68 N•m).

Go to Sheet 9

Para. 4-30, Task 2

4-229