TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 301 of 488

TM 9-2520-272-34&P

4-30. ASSEMBLE CENTER HOUSING

(SHEET 14 OF 20

NOTE

Leave hoist hooked to hydrostat so that you

can raise and turn hydrostat as necessary to

align bolt holes.

8 Using socket, install six bolts (10) and washers (11) in

hydrostat (2).

9 Remove hoist, S-hook, and eyebolt from hydrostat (2).

10 Using torque wrench and adapter, tighten six bolts (10)

to 36-43 Ib-ft (49-69 N•m).

FOLLOW-UN PROCEDURE:

Install steer control

assembly. Refer to this paragraph TASK 5.

End of Task 4

TASK 5. INSTALL STEER CONTROL ASSEMBLY

COMMON TOOLS:

Adapter, socket wrench, 1/2 inch to 3/8 inch square drive

Extension, socket wrench, 3/8 inch square drive, 6 inch

Handle, socket wrench 3/8 inch square drive

Socket, socket wrench, 3/8 inch square drive, 1/2 inch

Socket Head Screw Attachment, socket wrench, 3/8 inch square drive, 3/8 inch hex plug end

Wrench torque, 0-175 ft-lb

Wrench torque, 0-600 in-lb

SUPPLIES:

Sealant, lubricating, thread-locking (Item 16, Appendix C)

PRELIMINARY PROCEDURE:

Hydrostat is installed. Refer to this paragraph TASK 4.

Go to Sheet 15

Para. 4-30, Task 5

4-235