TM-9-2520-272-34P
CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A
TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
TM-9-2520-272-34P - Page 68 of 488
TM 9-2520-272-34&P
4-5.
REMOVE TRANSMISSION TOP COMPONENTS (SHEET
3 OF 8)
TASK 2.
REMOVE WIRING HARNESS ASSEMBLY
COMMON TOOLS:
Handle, socket wrench, 1/2 inch square drive
Extension, socket wrench, 1/2 inch square drive, 6 inch
Screwdriver, cross-tip, No.
1 tip
Screwdriver, flat tip
Socket, socket wrench, 1/2 inch square drive, 1/2 inch
SUPPLIES:
Cloth, lint-free (Item 6, Appendix C)
Twine, cotton, 16 ply, 30 inches (Item 21, Appendix C)
NOTE
•
cover assembly is removed from transmission.
•
harness can be removed without removal of solenoids or control valve assemblies.
•
harness does not have to be removed to remove control valve assemblies.
1
Clean wiring harness connector body (1) and
transmission area around connector.
2
Using cross-tip screwdriver, remove four screws
(2) holding harness connector body (1) to
transmission.
3
Using flat tip screwdriver, unfasten seven plastic
connectors (3) that attach harness (4) to solenoids
(5).
4
Using socket, remove bolt (6) and washer (7)
holding harness ground connector (8) to main
control valve assembly (9).
Go to Sheet 4
Para.
4-5, Task 2
Change 2
4-7
Back to Top
