TM-9-2815-202-34

ENGINE, DIESEL W/CONTAINER: MODEL 7083-7395, 7083-7396, 7083-7398 AND 7083-7399

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

FEBRUARY 1990

TM-9-2815-202-34 - Page 361 of 670

(36)

(37)

(38)

(39)

TM 9-2815-202-34

Loosen locknut (74) and remove buffer screw assembly (75).

Remove screw and washer assembly (76) and locking clip (77) securing operating lever

shaft (78) to governor housing (3).

Remove operating lever shaft (78), control link operating lever (79), and two washers (80).

If bearings are damaged, support control link operating lever (79) on sleeve and rest sleeve

on bed of arbor press. Place bearing remover (55) on top of bearing (81) and press two

bearings (81 ) out of operating lever (79).

(40)

(41)

(42)

(43)

(44)

Remove expansion plug (82) from

bottom of governor housing (3).

Discard expansion plug.

Remove operating shaft upper

bearing retainer screw and washer

assembly (83) and flat washer (84)

securing bearing in governor housing

(3).

Place governor housing (3) in press,

bottom side up.

Press operating shaft (85) out of lower

bearing (86) located in governor

housing (3).

Place a 9/16 inch open end wrench

(87) under operating fork (88) and

press fork off operating shaft (85).

4-253