TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 5 of 596
TM 9-2815-205-34
SUMMARY OF WARNINGS
Fuel spraying on hot components is an extreme fire hazard. Control leakage
immediately to prevent fires and injury.
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles
and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and
clothes. Do not breathe vapors. Do not use near open flame or excessive heat.
The flash point is 100-138°F (38-50°C). If you become dizzy while using cleaning
solvent, get fresh air immediately and seek medical aid. If contact with eyes is
made, wash with water and get medical aid immediately.
Compressed air used for cleaning purposes will not exceed 30 PSI. Use only
with effective chip guarding and personal protective equipment (goggles/shield,
gloves, etc.)
When inspecting a blower on a running engine, keep fingers, equipment and
clothing away from moving parts of the blower. Run engine at low speeds only.
I WARNING I
Wear safety glasses and stand clear of air release ports when purging air from
container. Make certain air pressure is fully vented before disassembly. Injury
to eyes and inner ears can result from failure to properly vent container before
disassembly.
I WARNING I
Never crawl under equipment when performing maintenance unless equipment
is securely blocked. Keep clear of equipment when it is being raised or lowered.
Do not allow heavy components to swing while suspended by lifting device.
Exercise caution when working near a cable or a chain under tension.
Equipment may drop or shift and injury to personnel may result.
a
Back to Top
